Plate vulcanizer

Steam heats the four guide / support columns to better maintain the parallelism of the pressing plate. From the closing of the pressing plate to the compression process, the speed is automatically converted.

The integrated hydraulic system (high-efficiency tefc motor, hydraulic cylinder, dial gauge, water-cooled heat exchanger) is equipped with stainless steel mesh protection to isolate the operator and prevent hazards. The steel base with forklift port makes the handling of equipment more convenient.

Hydraulic system this hydraulic system uses a variable displacement pump to regulate the high / low pressure oil circuit. This variable displacement pump delivers hydraulic oil to a solid, two-way IC cylinder.

The large flow / low pressure oil circuit is used to start and close the pressing plate at the set speed.

The small flow / high pressure oil circuit is used to apply the clamping force at the bottom clamping speed. The clamping force is set by the control panel, controlled by the pressure valve and displayed by the 100mm diameter pressure gauge.

Pressing plate structure

-The pressure plate is equipped with a coil type hot steam channel.

-There is an insulating layer between the pressing plate and the back plate to prevent heat loss and

transmission to the rack

-Each pressing plate is equipped with a digital temperature display on the control panel.

In addition, the pressure plate can also be equipped with air purging to purge the water vapor in the pressure plate coil after the test.

Electric control cabinet

Control system: NEMA point control cabinet

Including: PLC small operation interface

Programmable controller test count

Operation button, safe start with both hands

Button fine adjustment button for "slow mode closing" position adjustment and "test reset" indicator

Clamping pressure valve and display table

400v3 phase 50Hz power supply

Circuit breaker protection